How to Do Floor Sanding the Right Way

When it comes to DIY floor sanding, you need to know your stuff if you want it to go smoothly and effectively. You don’t want to use an ordinary floor sander because this will only lead to you wasting your time and effort. Sure, you might think that sanding wood floors or even removing wallpaper is not that complicated, but you’d be surprised. With proper planning and guidance, you will be able to get the floor sanding Adelaide job done efficiently and more smoothly.

DIY floor sanding doesn’t have to be tough on your wallet or your body either. Get the Ultimate Floor Sanding Guide by following the simple steps found here. If at any time in doubt, trust the pros to give you expert advice, guidance or handiwork so that your floors look stunning even for the years to come. Here are some simple tips that you can use:

Wood floors will usually need sanding or varnishing. This can be a lot of work, especially if you have already had wood floors installed. However, many people still prefer to have this done because it gives a better finish. If you have done some research, you might have learned that hardwood floors tend to fade over time due to exposure to sunlight, air-conditioning and chemicals used in cleaning. When the varnish has worn off, the wood will no longer be as shiny as it was when it was newly varnished. This is why it is recommended to use hardwood floor sanding methods.

If your wood floors have edges or if you want to make your floorboards look polished and sharp, you will probably need to use a sander. It is recommended that you go with a higher grit paper than that of your floor sanding paper so that the floorboards have a smooth finish. You could also use a power sander but be aware that you will need the help of an experienced pro for this one. Using a power sander on wooden floors without a good edging sander could cause your wood floorboards to split.

Before starting, be sure that you are wearing the proper protective equipment such as safety glasses and shoes. The next step involves the actual floor sanding procedure, which would take you about two to four hours, depending on how rough or smooth your floors are. Start by sandpaper the floors until they are nice and flat. Using a power sander, you could probably get away with just sandpaper and another small grit sandpaper.

Do not forget to sand the surrounding areas, such as walls, baseboards and floor fixtures. Then, it would be best if you vacuum cleaner your floor sanding. If you have a wall before sanding, be sure to tap on it with the vacuum cleaner head to eliminate any excess dust particles, and this will prevent scratches from appearing later on.

After you have finished with floor sanding Adelaide, you could opt to use a random orbital sander. A random orbital sander uses coarse grains that are more similar to that of sandpaper. Because these are not evenly distributed, they will leave scratches on your surface, unlike the fine grit floor sanding paper.

But, if you are looking to apply floor sanding on smaller spaces like a room floor, you should know that you can use either the fine grit or the coarse grit sandpaper. However, before you decide to use either, make sure that you read the instructions carefully not to make a mistake. Also, remember that you should only use the drum sander on a piece of wood that is perfectly level, and do not use it on uneven surfaces. In addition, be sure to wear protective eyewear such as goggles and earplugs while using the drum sander to ensure that you don’t inhale any dust particles contained within the sandpaper bag.